VIBRO HAMMER INSTALLATION PROCEDURES
Turn your excavator into a pile driver/extractor
in less than 60 minutes!
 |
 |
 |
| Step 1: Unpin Bucket - Drive Out Bucket Pins. | Step 2: Remove Bucket. | Step 3: Pin On Mounting Bracket. |
 |
 |
 |
| Step 4: Tie Down Bracket Link Securely. | Step 5: Pin On Vibro Hammer. | Step 6: Connect Bucket Cylinder Lines, Case Drain and Clamp Circuit, Wire, & Switch to Vibro Hammer. Install Clamp Switch in Cab. |
 |
 |
| Step 7: Installation Complete. | Step 8: Start Pile Driving or Extracting. |